Fossil Knock-off Bracelet

One of my favorite blogs to read is Flamingo Toes. This lovely lady has a quite a knack for making Anthropologie jewelry and when I was wandering around Fossil the other day I spied a bracelet and thought...I can make that!!
So here is my lovely attempt. I must admit it was quite fun.
Small disclaimer: some shots are far away because I was an idiot and didn't realize the macro function on my camera is for close-up shots. Apologies all around!

Here is their version:
It's called the Half and Half bracelet.
via the fossil website

Here is my version:



Fossil sells there's for $38, I made mine for about $7.

The supplies I used are readily available in the jewelry section of your craft store (and the fabric section).

Supplies:


-chain
-jeweled chain (can't think of a better name for this)
-cotton ribbon (ivory or white)
-embroidery floss or comparable thick thread in ivory
-big sewing needle
-jewelry wire cutters
-a decorative button (not pictured)
-patience

First: I took the cotton ribbon and wrapped it around my wrist twice, leaving two inches on each end for wiggle room.


Next: I measured across my wrist to see how much of each chain would cover the top of my wrist. It ended up being about six inches, but for wiggle room, I gave myself just over six and half inches.
Cut both chains with your wire cutters.



I cut two lengths of the jeweled chain because the one I found is not as wide as the ribbon.


Next: I folded the ribbon exactly in half and put a pin in the middle so I would know where to begin stitching the chains on.


Next: I flattened my regular chain onto the ribbon and with my threaded needle, stiched down the first link. I had to pin the chain farther down to the cotton ribbon because it kept getting tangled. This helped greatly and I recommend it!


Then: Just do a regular stitch on the rest of the chain, trying your best to hide the thread underneath where the links are joined. This took some practice, but with the thread being the same color as the cotton ribbon, it isn't that noticable.
**Tip** I would recommend a thick chain for this project. You could do a smaller chain and probably layer it up for a different look, but keep in mind the difficulty of threading and stitching it onto the ribbon.





Next: After you have the regular chain stitched down, time to stitch down the jeweled chains. I laid both chains next to one another on the ribbon and stitched over one, went under and stitched the other chain down. I didn't do one big stitch across both chains. I didn't want the jewels to be too close together.


Again, you'll want to pin down the chain farther along on the ribbon so they don't get tangled in with your stitching thread.

Next: Just continue the back and forth pattern of stitching the jeweled ribbon. I recommend a movie or music playing in the back ground so you don't get bored.




Finally: At the very end of the jeweled chain I stitched an ivory button from my stash as the closure. The Fossil version had a metal button, but I like mine better.



--Downton Abbey on my iPhone, available on Netflix instant play--


I wrapped the bracelet around my wrist again and judged where I would need a hole on the other end of the bracelet to put the button through. I just clipped a small opening in the ribbon and put fabric glue (fray check would work too) on the edges, so it wouldn't fray.
I clipped ends, applied a little more fabric glue, and I was finished.




Knock-off complete! :)








I'm going to peruse the website and the store for more bracelets and necklaces to try. This was so fun!

I'll be linking here: